[45272] Zinc through bolt fischer FBN II 12/5 K M12 x 86


£ 24.76 £ 24.76 24.76 GBP / 20

£ 24.76 / 20 not combination_info.get('is_rental')

    This combination does not exist.

    The fischer bolt anchor FBN II K is a short steel anchor for fixings in non-cracked concrete.

    Unit of Measure Name: 20
    Internal Reference: 45272

     0161 672 3333

    Terms & Conditions


    The fischer bolt anchor FBN II K is a steel anchor for cost-effective fixings in non-cracked concrete. The short version is suitable for pre-positioned installation and push-through installation. The bolt anchor is made of hot-dipped steel and is recommended for railings, handrails or consoles.

    Product Features

    • The standard anchorage depth achieves the maximum load-bearing capacities. This means that fewer fixing points and smaller anchor plates are required.

    • The reduced anchorage depth reduces the drill hole depth. This minimises the amount of time needed for installation whilst increasing flexibility.

    • The first bolt anchor with variable working life covers the usage of bolt anchors in wet conditions and outdoor areas.

    • The long thread balances component tolerances and stand-off installations, and thus increases flexibility.

    • Fewer hammer blows and the minimal torque slippage allow for a noticeably simpler assembly.

    • The drive-in pin protects the threaded screw from damage, and as such ensures a faster installation and dismantling of the fixture.


    • Steel constructions

    • Guard rails

    • Consoles

    • Ladders

    • Machines

    • Gates

    • Façades

    Building materials

    • Approved for:

    • Concrete C20/25 to C50/60, non-cracked

    • Also suitable for:

    • Concrete C12/15

    • Natural stone with dense structure

    • You can find detailed information on building materials in the registration document.


    • ETA-07/0211

    • ETA-18/0101

    • DoP 0192

    • DoP No. 0015

    • DoP No. 0098


    • The FBN II is suitable for pre-positioned and push-through installation; also suitable for stand-off installation under certain conditions.

    • Prior to installation, place the hexagon nut in the optimal position (the drive-in pin projects by approx. 3 mm out of the hexagon nut).

    • When applying the torque, the cone bolt is pulled into the expansion clip and expands it against the drill hole wall.

    • The head embossing offers a simple control of the anchoring.

    • In the case of series installation, we recommend using the FABS bolt anchor setting tool.

    Mounting Strip 1 PictureMounting Strip 1 PictureMounting Strip 1 PictureMounting Strip 1 PictureMounting Strip 1 Picture

    Documents for download

    Document NameDownload
    Load Table

    ETA Approval

    Declaration of Performance 1

    Declaration of Performance 2